- #2011 MACBOOK PRO WINDOWS 10 SETUP WITHOUT OPTICAL DRIVE INSTALL#
- #2011 MACBOOK PRO WINDOWS 10 SETUP WITHOUT OPTICAL DRIVE DRIVERS#
- #2011 MACBOOK PRO WINDOWS 10 SETUP WITHOUT OPTICAL DRIVE FULL#
Performance: The 2011 unibody Macbook Pros can utilize a SATA III (6 Gb/s connection) in the hard drive bay, taking advantage. I managed to use David Anderson's guide (answer below) to install windows 8.1 on a Late 2011 Macbook pro 15', with a 500GB SSD (OSX 10.13.6 High Sierra installed, APFS partition on the entire disk), and the original 500GB HDD on the superDrive Slot. Be aware of this if you upgraded to a 1TB hard drive early on as some were 12.5mm. FYI: A lot of the optical bay 'caddys' only accept a 9.5mm hard drive. I also have a USB to SATA cable I'm thinking of using to test the drive to see if it's maybe the Optibay or ribbon cable's fault. The unibody macbook pro can take up to 12.5mm height hard drive.
#2011 MACBOOK PRO WINDOWS 10 SETUP WITHOUT OPTICAL DRIVE FULL#
transferring to the NTFS side of HDD from within Windows.Īny thoughts or advice? I'm considering installing Windows to the HDD, giving OSX full reign of the SSD, and putting a FAT32 shared partition on the HDD.
The weird part is that large file transfers work fine on the Windows side, i.e. Transfer this bracket to your new optical drive or hard drive enclosure. DriverPack software is absolutely free of charge.
#2011 MACBOOK PRO WINDOWS 10 SETUP WITHOUT OPTICAL DRIVE DRIVERS#
Remove the two black Phillips 0 screws securing the small metal mounting bracket. Apple MacBook Pro (13' Early 2011) laptop drivers for Windows 10 圆4. Be sure to pull by the edges of the connector, not by the cable itself. I've tried disabling the sudden motion sensor in Terminal and telling it not to spin down drives when it's plugged in. Pull the optical drive cable out of the optical drive. After unmounting, the drive won't show up at all in Disk Utility and the "SATA" section of System Information just displays an unknown device. iso files, my music library, etc) to the HFS side of the drive, usually after about 5 minutes both of the partitions on the drive will unmount and display a message about not being ejected properly. When I'm doing large file transfers (DVD. You can do this using the Bootcamp Assistant, but it does reboot and attempt to boot from the optical drive as soon as it completes.
Installing Kali Linux (Single boot) on Apple Mac hardware (such as. Windows 10 will install and run without them but not very well and a lot of hardware either wont work, or wont work very well until you install the drivers. The 1TB HDD is split into 2 partitions: an NTFS side for Windows file storage and an HFS+ side for OSX storage. The model & year of the device will determine how successful your experience will be. I’m seeing random cursor disappearing, however. 13.3-inch (diagonal) LED-backlit glossy widescreen display with support for millions of colors. However, writes max out at 275 MBs, while reads are great at 475 MB/s. The stock 120GB SSD houses an OSX Mavericks install and a Windows 7 install, done basically via Bootcamp. Installed the 240 GB Mercury Pro Extreme in the main bay of late 2011 17-inch. I recently installed a 1TB HDD in my early 2011 13" MacBook Pro using an MCE Optibay.
0 kommentar(er)
